●
Oil level warning light
●
Engine trouble warning light
●
Traction control system indi-
cator/warning light
●
Cruise control indicator lights
●
Electronically adjustable sus-
pension system warning light
●
Shift down indicator light
●
YCC-S system warning light
●
Stop mode function indicator
light
●
Immobilizer system indicator
light
TIP
If the stop mode function was activated
when the key was turned to "OFF" then
the stop mode function is still activated
and the indicator light will remain on.
NOTICE
If a warning or indicator light does
not come on initially when the key is
turned to "ON", or if a warning or in-
dicator light remains on, see page
3-4 for the corresponding warning
and indicator light circuit check.
OPERATION AND IMPORTANT RIDING POINTS
The ABS warning light should
come on when the key is turned to
"ON", and then go off after travel-
ing at a speed of 10 km/h (6 mi/h)
or higher.
NOTICE
If the ABS warning light does not
come on and then go off as ex-
plained above, see page 3-4 for the
warning light circuit check.
2. Shift the transmission into the neu-
tral position. The neutral indicator
light should come on. If not, ask a
Yamaha dealer to check the elec-
trical circuit.
3. Start the engine by pushing
the "
" side of the start/engine
stop switch with the front or rear
ECA11833
brake applied.
If the engine fails to start, release
the start/engine stop switch, wait a
few seconds, and then try again.
Each starting attempt should be as
short as possible to preserve the
battery. Do not crank the engine
more than 10 seconds on any one
attempt.
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
cold!
ECA17681
5-2
ECA11042
5