Yamaha PW50 Owner's Manual page 64

Periodic maintenance and adjustment
1
1. Wheel axle
To install the front wheel
1. Install the brake shoe plate into
the wheel hub as shown.
7
2. Lift the wheel up between the fork
legs.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
1. Retainer
1
3. Insert the wheel axle from the right
side.
4. Install the washer and axle nut,
and then tighten the axle nut to the
specified torque.
Tightening torque:
Axle nut:
40 Nm (4.0 m·kgf, 29 ft·lbf)
5. Connect the brake cable at the
wheel hub, and then install the
brake lever free play adjusting nut.
6. Adjust the brake lever free play.
(See page 7-16.)
7. Take the motorcycle off the cen-
terstand so that the front wheel is
on the ground.
8. Push down hard on the handlebar
several times to check for proper
fork operation.
7-23