Middle And Final Gear Cases - Yamaha PW50 Owner's Manual

Periodic maintenance and adjustment
4. Install the transmission oil drain
bolt and its new gasket, and then
tighten the bolt to the specified
torque.
Tightening torque:
Transmission oil drain bolt:
14 Nm (1.4 m·kgf, 10 ft·lbf)
5. Refill with the specified amount of
the recommended transmission
oil, and then install and tighten the
oil filler cap.
Recommended transmission oil:
See page 9-1.
Oil change quantity:
0.30 L (0.32 US qt, 0.26 Imp.qt)
NOTICE
 In order to prevent clutch slip-
page (since the transmission oil
7
also lubricates the clutch), do
not mix any chemical additives.
Do not use oils with a diesel
specification of "CD" or oils of a
higher quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
 Make sure that no foreign mate-
rial enters the transmission.
6. Start the engine, and then let it idle
for several minutes while checking
the transmission for oil leakage. If
oil is leaking, immediately turn the
engine off and check for the cau-
se.

Middle and final gear cases

The middle and final gear cases must
be checked for grease leakage before
each ride. If any leakage is found, have
a Yamaha dealer check and repair the
motorcycle.
Yamaha dealer check and lubricate the
middle and final gears at the intervals
specified in the periodic maintenance
and lubrication chart.
ECA10453
7-9
In addition, have
EAU41712
a