Auxiliary Dc Jack - Yamaha KODIAK 700 YFM70KDXH Owner's Manual

EBU19184

Auxiliary DC jack

The auxiliary DC jack is located at the front right
side of the ATV. The auxiliary DC jack can be used
for suitable work lights, radios, etc. The auxiliary
DC jack should only be used when the engine is
running and the light switch is set to "OFF".
1. Set the light switch to "OFF".
4
2. Turn the accessory off.
3. Start the engine. (See page 6-1.)
4. Open the auxiliary DC jack cap, and then in-
sert the accessory power plug into the jack.
1. Auxiliary DC jack cap
2. Auxiliary DC jack
ECB00121
 Do not use accessories requiring more than
 If accessories are used without the engine
1
2
 Do not use an automotive cigarette lighter or
4-26
Maximum rated capacity for the auxiliary DC
jack:
DC 12 V, 10 A (120 W)
5. Turn the accessory on.
6. When the auxiliary DC jack is not being used,
cover it with the cap.
NOTICE
the above maximum capacity. This may
overload the circuit and cause the fuse to
blow.
running or with the headlights turned on, the
battery will lose its charge and engine start-
ing may become difficult.
other accessories with a plug that gets hot
because the jack can be damaged.