Storage - Toro 30834 Operator's Manual

2. Insert a punch through the end of the roller housing
and drive the opposite bearing out by alternating taps
to the opposite side of inner bearing race. There should
be a 0.060 inch (1.5 mm) lip of inner race exposed.
3
4
1
Figure 17
1. Front roller
2. mounting bolt
3. Push the second bearing out in press.
4. Inspect the roller housing, bearings, and bearing spacer
for damage (Figure
and assemble.
Assembling the Front Roller
1. Press the first bearing into the roller housing
17). Press on the outer race only or equally on the
inner and outer race.
2. Insert the spacer (Figure
3. Press the second bearing into the roller housing
17) pressing equally on the inner and outer race until
the inner race comes in contact with the spacer.
4. Install the roller assembly into the deck frame.
Important: Securing the roller assembly with a
gap larger than 0.060 inch (1.5 mm) creates a side
load on the bearing and can lead to premature
bearing failure.
5. Verify that there is no more than a 0.060 inch gap
between roller assembly and the roller mount brackets
of the deck frame. If there is a gap over 0.060 inch,
install enough 5/8 inch diameter washers to take up
the slop.
6. Secure the mounting bolt to 80 ft-lb (108 N-m).
2
G011356
3. Bearing
4. Bearing spacer
17). Replace damaged components
17).

Storage

If the cutting deck is separated from the traction unit for any
length of time, install a spindle plug in the top of the spindle
to protect the spindle from dust and water.
(Figure
(Figure
13