3.5-Inch Hard Drive - Seagate SRPS20 User Manual

Consider the points below before following the instructions:
Replace an existing or faulty hard drive with a hard drive of equal or greater capacity.
When handling hard drives, make sure that they are placed (and stored) on a cushioned surface.
If you are replacing a 3.5-inch hard drive with a 2.5-inch hard drive, make certain to use the screws
included with the NAS.
Important info: The WSS NAS only accepts internal 3.5-inch SATA hard drives. Do not use 3.5-

inch hard drives built for external storage or SAS hard drives. Seagate hard drives are optimized
for use with your NAS. See

3.5-inch hard drive

1. Push the hard drive tray's lock button to open the latch and remove the hard drive tray. Important: Make
certain that you remove the correct hard drive tray.
2. Insert a new hard drive or replace the current hard drive.
Empty tray: gently bend the left side of the tray and connect the hard drive to the two pins on the
right.
Seagate WSS NAS 2-Bay | 4-Bay | 6-Bay
Seagate NAS HDD for further information.
4/13/15 54