Stopping The Engine; Checking Unit Condition; Operation - Shindaiwa T344 Owner's/Operator's Manual

Starting A Flooded Engine
1. Slide the ignition switch to the "I" (ON) position.
2. Open the choke, put the throttle lever in the full throttle position, then clear excess fuel from the combustion chamber by
cranking the engine several times.
3. If the engine still fails to start or fire, refer to the troubleshooting flow chart at the end of this manual.

Stopping the Engine

Idle the engine briefly before stopping (about 2 minutes), then slide the
ignition switch to the "O" (Engine OFF) position.

Checking Unit Condition

NEVER operate the unit with the cutting attachment shield or other protective devices removed!
Use only authorized Shindaiwa parts and accessories with your Shindaiwa trimmer. Do not make modifications to this unit without
written approval from Shindaiwa.
ALWAYS make sure the cutting attachment is properly installed and firmly tightened before operation.
NEVER use a cracked or warped cutting attachment; replace it with a serviceable one.
ALWAYS make sure the cutting attachment fits properly into the appropriate attachment holder. If a properly installed
attachment vibrates, replace the attachment with new one and re-check.
ALWAYS stop the engine immediately and check for damage if you strike a foreign object or if the unit becomes tangled.
Do not operate with broken or damaged equipment.
NEVER allow the engine to run at high RPM without a load. Doing so could damage the engine.
NEVER operate a unit with worn or damaged fasteners or attachment holders.
WARNING!
A cutting attachment shield or other protective device is no guarantee of protection against ricochet. YOU
MUST ALWAYS GUARD AGAINST FLYING DEBRIS!

Operation

WARNING!
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas. Breathing CO can cause unconsciousness,
serious injury, or death. Exhaust can cause serious burns. ALWAYS position unit so that exhaust is directed away from
your face and body.
WARNING!
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from
all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit.
OFF
Slide ignition to OFF
13