D-Link DWL-8710AP Quick Installation Manual page 9

Professional installation instruction (for FCC)
1. Installation personal
This product is designed for specific application and
needs to be installed by a qualified personal who has RF
and related rule knowledge. The general user shall not
attempt to install or change the setting.
2. Installation location
The product shall be installed at a location where the
radiating antenna can be kept 24cm from nearby person
in normal operation condition to meet regulatory RF
exposure requirement.
3. External antenna
Use only the antennas which have been approved by the
applicant. The non-approved antenna(s) may produce
unwanted spurious or excessive RF transmitting power
which may lead to the violation of FCC limit and is
prohibited.
4. Installation procedure
Please refer to user's manual for the detail.
5. Warning
Please carefully select the installation position and make
sure that the final output power does not exceed the limit
set force in relevant rules. The violation of the rule could
lead to serious federal penalty.
Professional installation instruction (for IC)
1. Installation personal
This product is designed for specific application and
needs to be installed by a qualified personal who has RF
and related rule knowledge. The general user shall not
attempt to install or change the setting.
2. Installation location
The product shall be installed at a location where the
radiating antenna can be kept 30cm from nearby person
in normal operation condition to meet regulatory RF
exposure requirement.
3. External antenna
Use only the antennas which have been approved
by the applicant. The non-approved antenna(s) may
produce unwanted spurious or excessive RF transmitting
power which may lead to the violation of IC limit and is
prohibited.
4. Installation procedure
Please refer to user's manual for the detail.
5. Warning
Please carefully select the installation position and make
sure that the final output power does not exceed the limit
set force in relevant rules. The violation of the rule could
lead to serious federal penalty.
Instructions d'installation professionnelle
1. Installation
Ce produit est destine a un usage specifique et doit
etre installe par un personnel qualifie maitrisant les
radiofrequences et les regles s'y rapportant. L'installation
et les reglages ne doivent pas etre modifies par l'utilisateur
final.
2. Emplacement d'installation
En usage normal, afin de respecter les exigences
r e g l e m e n t a i r e s c o n c e r n a n t l 'e x p o s i t i o n a u x
radiofrequences, ce produit doit etre installe de facon a
respecter une distance de 30cm entre l'antenne emettrice
et les personnes.
3. Antenn externe.
Utiliser uniiquement les antennes approuvees par le
fabricant. L'utilisation d'autres antennes peut conduire
a un niveau de rayonnement essentiel ou non essentiel
depassant les niveaux limites definis par IC, ce qui est
interdit.
4. Procedure d'installation
Consulter le manuel d'utilisation.
5. Avertissement
Choisir avec soin la position d'installation et s'assurer que la
puissance de sortie ne depasse pas les limites en vigueur.
La violation de cette regle peut conduire a de serieuses
penalites federales.
低功率電波輻射性電機管理辦法
第十二條 經型式認證合格之低功率射頻電機，非經許
可，公司、商號或使用者均不得擅自變更頻率、加大
功率或變更原設計之特性及功能。
第十四條 低功率射頻電機之使用不得影響飛航安全及
干擾合法通信；經發現有干擾現象時，應立即停用，
並改善至無干擾時方得繼續使用。
前項合法通信，指依電信法規定作業之無線電通信。
低功率射頻電機須忍受合法通信或工業、科學及醫療
用電波輻射性電機設備之干擾。
電磁波曝露量MPE標準值1mW/cm2，本產品使用時建
議應距離人體 24 cm。