Table of Contents
Advertisement
5. Remove the protective caps covering the
antenna ports on the AP, if any. Next, connect the
2 antennas marked "2.4 GHz" to the designated
2.4 GHz connectors and the antennas marked
"5 GHz" to the designated 5 GHz connectors
on the AP. The DWL-8710AP is now ready to be
connected to the network.
Figure 12: Attaching the antennas
Mounting the AP to a Pole
The DWL-8710AP can be mounted either horizontally
or vertically. However, it is recommended that the AP
is installed with the antennas positioned vertically
in order to achieve optimal performance.
1. Place the lock and flat washer on the cap screws
and attach the mounting plate to the back of the
DWL-8710AP.
Figure 13: Mounting the base plate
2. Depending on the orientation of the pole
you wish to install the AP onto (horizontal or
vertical), attach the pole mounting bracket to
the mounting base plate accordingly using the
screws. Refer to figure 13 for the proper position
of the pole mounting bracket for each direction.
Figure 14: Attaching the pole mount base
3. Thread the open end of the pole strap through
the two tabs on the pole mounting bracket to
secure the strap to the mounting bracket.
Figure 15: Attaching the pole strap
5
Hide quick links:
Advertisement
Table of Contents
