Filling The Engine With Oil - Toro 20373 Operator's Manual

1. Recoil-starter rope
4

Filling the Engine with Oil

No Parts Required
Procedure
Important: Your machine does not come with oil in
the engine. Before starting the engine, fill the engine
with oil.
Max. fill: 0.59 L (20 oz), type: SAE 30 or SAE 10W-30
detergent oil with an API service classification of SF, SG, SH,
SJ, SL, or higher.
Note: When the crankcase is empty, pour about 3/4 of
the crankcase capacity of oil in the crankcase, then do the
following:
1. Move the machine to a level surface.
2. Remove the dipstick
Figure 5
2. Rope guide
(Figure 6).
1. The oil level is at its
maximum.
2. The oil level is too
high—remove oil from
the crankcase.
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube but do not
screw it in, then remove the dipstick.
5. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low, slowly
pour a small amount of oil into the oil-fill tube,
wait 3 minutes, and repeat steps
the oil level on the dipstick is at the correct level.
•
If the oil level on the dipstick is too high, drain the
excess oil until the oil level on the dipstick is at
the correct level. Refer to
Oil (page 17).
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
6. Install the dipstick securely.
Important: Change the engine oil after the first 5
operating hours ; change it yearly thereafter. Refer
to Changing the Engine Oil (page
7
G017323
Figure 6
3. The oil level is too
low—add oil to the
crankcase.
(Figure 6).
3 through
Changing the Engine
17).
5 until