● Connection
1. Set the switch (SW7) of RS232C conversion
adaptor to the "FLASH UCOM" position. (Fig. 1)
2. Connect the writing port (CB902 of OPERATION
P.C.B.) located on the rear panel of this unit to the
serial port (RS232C) of the PC with RS232C cross
cable, RS232C conversion adaptor and flexible
flat cable as shown below. (Fig. 1)
PC
Serial port (RS232C)
RS232C cross cable
RS232C クロスケーブル
● 接続
1. RS232C 変換アダプターのスイッチ (SW7) FLASH
UCOM 側に設定します。 (Fig. 1)
2. 本機の書き込み用ポート (OPERATION P.C.B. の
CB902) と PC のシリアルポート (RS232C) を下記
のように接続します。 (Fig. 1)
This unit
RS232C conversion adaptor
RS232C変換アダプター
FLASH
Flexible flat cable (9P)
OTHER
UCOM
カード電線 (9P)
SW7
Fig. 1
CD-S300
17