Disassembly Procedures - Yamaha CDC-697 Service Manual

CDC-697
I DISASSEMBLY PROCEDURES
(Remove parts in the order as numbered.)
1. Removal of Top Cover
a. Remove 4 screws (1) and 3 screws (2). (Fig. 1)
b. Lift the top cover at the rear and move it rearward
slantingly.
2. Removal of Clamp Ass'y
a. Remove 2 screws (3). (Fig. 1)
b. Remove clamp ass'y. (Fig. 1)
3. Removal of Tray Ass'y
a. Remove 1 screw (4). (Fig. 1)
b. Turn gear/L0. (Fig. 2) Counter clockwise gradually
until immediately before the tray starts to move and
stop it there.
CAUTION: Gear/L0, if turned counter clockwise continu-
ously, will mesh with the gear of the tray and
the tray will come out. When removing the
tray, use care so that gear/L0 will not mesh
with the gear of the tray.
c. Pull out the tray ass'y.
4. Removal of Table
a. Remove 1 screw (5) and then remove the support/T.
(Fig. 1)
b. Remove the plate/table. (Fig. 1)
c. Remove 1 screw (6) and then take off the table.
(Fig. 1)
Top cover
1
Plate/Table
6
4
Table
Tray
Front panel unit
8
3
1
Clamp ass'y
5
Support/T
Fig. 1
Tray
Gear/L0
Fig. 2
• Precaution for installation of the Tray Ass'y.
On tray ass'y setting.
Check the direction of marking "
ing to this drawing.
Gear/L01
• IMPORTANCE: Installation of Table.
Install the table according to the following procedure.
1) Slide the lever so that the gear/RT1 becomes
free. (Fig. B-1)
2) With the "
H H H H H
the same mark on the tray, lock it with the lever.
(Fig.B-1)
2
3) Install the table by aligning it to the thick line on "
mark. (Fig. B-2)
* Check that the Table is locked after installa-
tion.
Gear/RT1
Tray
Lever
Lock
Unlock
Fit the table to the thick line on "
" on gear accord-
H H H H H
Gear/L0
Front panel
Marking
Fig. A
" mark on the gear/RT1 aligned with
Fit the gear/RT1 to "L" mark.
Fig. B-1
/
" mark.
Tray
Table
Fig. B-2
/
"