Table of Contents
Advertisement
Quick Links
S I M P L Y
A M A Z I N G
U
SER
XL2800HAY
HIGH SPEED UPRIGHT VACUUM
CLEANER WITH
CLEANING SYSTEM
•IMPORTANT•
SAVE THIS BOOKLET!
VISIT ONE OF OUR OVER
Includes:
450 STORE LOCATIONS
• Safety Warnings
• Warranty
• Operating Instructions
• Trouble Diagnosis
• Accessories
®
'
G
S
UIDE
®
USA: 1-800-989-4244
CANADA: 1-800-393-8801
Advertisement
Table of Contents
Related Manuals for Oreck XL2800HAY
Summary of Contents for Oreck XL2800HAY
- Page 1 S I M P L Y A M A Z I N G VISIT ONE OF OUR OVER 450 STORE LOCATIONS ® ’ UIDE XL2800HAY HIGH SPEED UPRIGHT VACUUM CLEANER WITH CLEANING SYSTEM •IMPORTANT• SAVE THIS BOOKLET! Includes: • Safety Warnings •...
-
Page 2: Table Of Contents
How to Replace a Worn Belt, To Adjust or Replace Brush ..page 7 Bulb Replacement, Stuffing or Blockage, Using an Oreck Fresh Air ® Tab ..page 8... -
Page 3: Maintenance And Customer Service
God, the use of voltages other than indicated on the serial number displayed on this product or service of this product by other than Oreck or a partici- pating Factory Authorized Service Center. -
Page 4: General Information
Connector Assembly PRESS UNTIL SNAP IS HEARD fig. 1 Before assembling appliance, remove two screws from the connector assembly. Remove cardboard insert by pulling upward. fig. 2 With ON/OFF switch facing the front of the unit, slide upper handle section over matching section of the connector assembly. -
Page 5: Operating Instructions
Operating Recommendations This new ORECK XL High-Speed Upright is one of the finest, fastest, and strongest units in its class. You’ll love the way it cleans, gets under things, and it’s SO lightweight and easy to use. -
Page 6: Operating Instructions For The Radio Handle
Celoc Hypo-Allergenic Filter System ® The CELOC SMMS outer bag of your vacuum cleaner is high filtration medical material designed to filter the smallest of dust particles. It is important that the inside of the outer bag be cleaned. Turned inside out, vacuum the inside of the outer bag or hand wash, with warm water and air dry. -
Page 7: How To Replace A Worn Belt, To Adjust Or Replace Brush
ow to eplace a WARNING: Unplug cord from electrical outlet before servicing. Remove the replacement belt from the storage channel. Remove the door by removing the hold down screw located on side of power head. Slide the door forward by prying open with a screwdriver or coin. -
Page 8: Using An Oreck Fresh Air
©2008 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used under the authority of Oreck Holdings, LLC. 4. To reassemble, check O-ring on tube, and replace if damaged.