Beurer BC 57 Instructions For Use Manual page 28

Adopt the correct posture
• Before every measurement, relax for about five min-
utes. Otherwise deviations can occur.
• You can take the measurement
while sitting or lying. To take your
blood pressure, make sure you are
sitting comfortably with your arms
and back leaning on something.
Do not cross your legs. Place your
feet flat on the ground. Make sure to rest your arm and
move it. Always make sure that the cuff is at heart level.
Otherwise significant deviations can occur. Relax your
arm and the palm of your hand.
• To avoid falsifying the measurement, it is important to
remain still during the measurement and not to speak.
Performing the blood pressure measurement
As described above, attach the cuff and adopt the pos-
ture in which you want to perform the measurement.
• Press the START/STOP button
start the blood pressure monitor. All
displays will illuminate briefly.
The blood pressure monitor will begin
the measurement automatically after 5
seconds.
The measurement is taken during the
inflation phase.
As soon as a pulse is found, the pulse symbol
played.
• The systolic pressure, diastolic pres-
• EE_ appears if the measurement
• Now select the desired user memory by pressing the
to
• Press the START/STOP button
If Bluetooth
ferred after pressing the START/STOP button
28
You can cancel the measurement at any time by
pressing the START/STOP button
sure and pulse rate measurements
are displayed.
could not be performed properly. Ob-
serve the chapter on error messages/
troubleshooting in these instructions for
use and repeat the measurement.
memory button M. If you do not select a user memory,
the measurement is stored in the most recently used
user memory. The relevant symbol M1 or M2 appears
in the display.
blood pressure monitor. The measurement is then
stored in the selected user memory.
® data transfer is activated, data is trans-
.
is dis-
to switch off the
.