Lexus RC350 User Manual page 563

Warning message
RC200t only

(U.S.A. only)
(If equipped)
(If equipped)
(Flashes)
(If equipped)
RC350_RC300_RC200t_RC F_U (OM24671U)
8-2. Steps to take in an emergency
Details/Actions
Indicates that the engine oil should be changed. (After
the engine oil is changed and the message has been
reset.)
 Check and change the engine oil, and oil filter by
your Lexus dealer. After changing the engine oil, the
message should be reset.
Indicates that all maintenance is required to correspond
to the driven distance on the maintenance schedule
Comes on approximately 5000 miles (8000 km) after
the message has been reset.
(The indicator will not work properly unless the message
has been reset.)
 Perform the necessary maintenance. Please reset
the message after the maintenance is performed
(P. 473)
Indicates that the Automatic High Beam switch is
pressed while the headlights are in low beam.
 Turn the high beam on and press the Automatic
High Beam switch again.
Indicates that, since the VSC (Vehicle Stability Control)
system was turned off, the pre-collision brake system
operation is stopped
Operation of the pre-collision brake assist and the
steering control (if equipped) of the PCS (Pre-Colli-
sion system) are also stopped.
 Turn the VSC on. (P. 290)
Indicates that the PCS (Pre-Collision System) is not cur-
rently functional because the grille cover or the sensor is
dirty
 Check the grille cover and the sensor and clean
them if they are dirty.
563
*
.
8