Get Started: Setup - Magellan eXplorist TRX7 User Manual

Get Started. References
Get Started at Home
Power On
Press the Power button on the right side
of the device to turn the device on.
Connect to Wi-Fi
1. Tap > >
Home screen.
2. Slide On/Off button to
3. Tap again to see networks.
4. Enter password (if applicable).
5. Tap .
Get Started in Your Vehicle
1. Get a clear view of the sky.
2. Clean the area on the windshield
where you want to mount the device.
Allow the surface to dry.
3. Hold the suction cup firmly against the
windshield surface
4. Push the lever down towards the base.
5. Screw the baseplate on the cradle.
6. Attach the device onto the mount.
from the
Troubleshooting for information about
.
alternate mounting solutions.
Connect to Wi-Fi Hot Spot
1. Tap
2. Slide the On/Off button to
3. Tap
4. Enter password (if applicable).
5. Tap
Note: Wi-Fi must be
TRX7 with your myTRXjournal account.
Various factors influence GPS signal
reception. To improve the signal reception
and time to calculate the current location:
• Leave any enclosed structure (garage,
• Make sure you have a 'clear view of the
• Make sure that the device is mounted
Note: The first time the device calculates its
location can take up to 1 minute. Subsequent
times will be 15 seconds on average.
Tip: Refer to FAQs and
> >
again to see networks.
.
Important
parking structures, etc.).
sky'. Buildings and trees can have an
impact on GPS signal reception.
where it can have a clear line of sight to
the windshield.
.
.
to sync your