Installing The Ups In A Rack - HP R/T2200 Installation Instructions Manual

3. From inside the bezel, gently push out the LED/Control panel,
rotate it 90 degrees, and then replace it in the bezel.
4. Replace the front bezel.
5. Stand the unit on its side with the LED/Control panel at the top.

Installing the UPS in a rack

Before installing the unit, review and adhere to all warnings
provided in "Precautions."
WARNING: To reduce the risk of personal injury or
damage to the equipment, be sure that:
• The leveling feet are extended to the floor.
The full weight of the rack rests on the leveling feet.
•
• The stabilizing feet are attached to the rack if it is a
single-rack installation.
• The racks are coupled together in multiple-rack
installations.
Only one component is extended at a time. A rack
•
may become unstable if more than one component is
extended for any reason.
NOTE: Mounting hardware for square- and round-holed
racks is included in the UPS kit.
1. Attach the 2U side-mounting brackets to the unit.
2. Loosen the wing nuts, and extend the brackets to the desired
length.
3. Insert screws through the rack into the mounting rail and the
front of each mounting bracket. Do not completely tighten the
screws.