NetVanta 1224STR DC Hardware Installation Guide
Domestic shipments of the NetVanta 1224STR DC include the following items:
•
NetVanta 1224STR DC base unit
•
Quick start guide
•
A detachable power cable with a grounded, three-prong plug
International shipments of the NetVanta 1224STR DC include the following items:
•
NetVanta 1224STR DC base unit
•
Quick start guide
•
All necessary power cords
Front Panel Design
The NetVanta 1224STR DC front panel is shown below. Table 1 on page 18 describes all of the LEDs, and
Appendix A on page 43 shows the connector pinouts.
NetVanta 1224STR DC Front Panel Features
Status LEDs
The status LEDs are located to the lower left of RJ-45 port 1. The
installed NIM. The
DBU
unit's status.
10/100Base-T Ethernet Interfaces
The NetVanta 1224STR DCs contain 24 10/100Base-T Ethernet interfaces (RJ-45). These interfaces
are consecutively numbered 1 through 24, from left to right, with the numbers screened directly above
each port. Status LEDs for each of these interfaces are located directly over these numbers.
Gigabit Ethernet Interfaces/SFP Slots
The NetVanta 1224STR DC front panel contains one Gigabit Ethernet interface that provides one fixed
RJ-45 connector and one standard SFP slot for fiber connectivity. (Use either the RJ-45 connector or
the SFP slot. The fiber slot has precedence.) This interface is labeled
to the left of RJ-45 port 1, above the
Rear Panel Design
The NetVanta 1224STR DC rear panel is shown below. Refer to Appendix A on page 43 for pinouts.
WAN-T1
61200590E1-34B
LED reflects the status of an installed DIM. The
LED.
STAT
Figure 1. Front Panel Layout
Figure 2. Rear Panel Layout
Copyright © 2013 ADTRAN, Inc.
Physical Description
WAN
LED reflects the status of an
STAT
LED indicates the
, and the status LED is located
G1
CONDUCTORS ONLY
+24V....., 2.5A
USE COPPER
-48V....., 1.2A
17