Bosch e103022 Installation Instructions Manual page 18

22
1
23
NOTE: If your dishwasher came with a fleece kit, follow the
directions supplied in that kit to install the fleece.
24
H
16
2
F
Attach drain hose to plumbing with
screw clamp (position 1 for 1/2"
[12.7 mm] connection or position
2 for 3/4" [19 mm] connection) and
tighten. Do not cut drain hose.
Attach water line to incoming
hot water shut off valve. Turn on
water and check for leaks. Turn
power back on at fuse box. Start
dishwasher and listen for water and
pump for water distribution. Press
Cancel/Reset to drain and check for
leaks.
NOTE: If your toe panel is plastic,
skip this step and go to steps
25-26.
Attach the metal toe panel (Part H)
with screws (Part F) so it is flush
with the floor.
Success! Your installation is now
complete.