Toro 30853 Operator's Manual page 18

Using the Menus
To access the InfoCenter menu system, press the menu access
button while at the main screen. This will bring you to the
main menu. Refer to the following tables for a synopsis of
the options available from the menus:
Main Menu
Menu Item
Faults
Service
Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Cutting Units
Hi/Low Range
PTO
Engine Run
Description
Contains a list of the recent
machine faults. Refer to
the Service Manual or your
Toro Distributor for more
information on the Faults
menu and the information
contained there.
Contains information on the
machine such as hours of use,
counters, and other similar
numbers.
Displays the state of each
machine switch, sensor, and
control output. You can use
this to troubleshoot certain
issues as it quickly tells you
which machine controls are
O and which are O .
N FF
Allows you to customize and
modify configuration variables
on the InfoCenter display.
Lists the model number, serial
number, and software version
of your machine.
Description
Lists the total number of hours
that the machine, engine, and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due.
Lists numerous counts the
machine has experienced.
Description
Indicates the inputs, qualifiers,
and outputs for raising and
lowering the cutting units.
Indicates the inputs, qualifiers,
and outputs for driving in
transport mode.
Indicates the inputs, qualifiers,
and outputs for enabling the
PTO circuit.
Indicates the inputs, qualifiers,
and outputs for starting the
engine.
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Protected Menus
Counterbalance
* Only "operator-faced" text is translated. Faults, Service, and
Diagnostics screens are "service-faced". Titles appear in the
selected language, but menu items are in English.
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
18
Description
Controls the units used on the
InfoCenter (English or Metric).
Controls the language used
on the InfoCenter*.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Allows the
superintendant/mechanic
to access protected menus by
inputting a passcode.
Controls the amount of
counterbalance applied to the
cutting decks.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.