Sears 113.29461 Owner's Manual page 7

U-CLIP
BASE C ROSS-MEMBER
Figure
1/
k. Adjust the right-hand table support in exactly the
same manner, without altering the radial-arm eleva-
tion setting.
Loosen the bevel lock knob and, while holding the
bevel latch-pin handle up, rotate the motor to a
horizontal position - then release the latch-pin
handle so that the pin bottoms in its detent, and
tighten the lock knob.
m. Move the radial arm to 0 ° (center) position and lock
it by tightening the arm-latch handle.
3. Installing the Front Table (Figures 11 through 15)
P_ace the front table (largest) board upside down on
a workbench or the floor. It is upside down when the
face in which the screw holes are counterbored is at
bottom. Note that there are two holes near the
center of the board, one smaller in diameter than the
other. Drive the T-nut (furnished with loose parts)
into the smaller of these two center holes.
Turn the front table top side up and place it on the
table supports, locating it so that the six screw holes
near the board sides are aligned with their corre-
sponding holes in the two supports.
C.
In each of the six boles located above the table
supports, place one 17/64-inch flat washer and one
1i4-20xl-inch pan-head machine screw. In the larger
of the two center holes place one 17!64-inch flat
washer and one 1/4-20xl 1!4-inch pan-head machine
screw - and start the screw into the U-nut on the
front of the saw base (but do not tighten it). In the
smaller center hole {with the T-nut underneath),
barely start the cup-point set-screw.
Install one 1!4-inch Iockwasher and one 1/4 20 hex
nut on each of the six screws in the table supports,
and tighten slightly. The board should be snug
against the supports, but not held too tightly to be
moved by tapping it firmly with a rubber mallet.
Figure
12
A CROSS_SECTIONA L
VIEW THROUGH
CENTER OF T-NUT
1t4 20x 1" PAN-HD. SCREW
F
F 17/64" FLAT WASHER
FRONT
_ _,
[----;/4t_i2Cx ,1 1/4"' PAN
lid
TABLE [/ "_i v, , I
1/4-LOCK °
1/4-20 I ,__
HEX NUT _ _" Figure 73
NOTE: Setscrew is shown as it will
be when tightened. For step 3c it
must not touch the saw base.
CUP-POI NT SETSCREW_
Figure 14
FRONTTABLE_______
E
REAR TABLE BOAR
Figure 15
1
FRONT TABLE
e. Move the carriage to its extreme rear position, and
tighten the carriage lock knob.
f. Lay the rear table board on edge across the front
table to serve as a straightedge. Sight under this
straightedge to determine whether the front table
board is high or low at its center.
g. If the front table is high at center, first tighten the
center (1/4-20x1-1/4-inch) hold-down screw until the
table is level - then tighten the leveling screw until
this screw is snug If table is low at center, hrst
tighten the leveling screw until the table is level -
then tighten the hold down screw.