Assembly And Adjustments - Sears 113.29461 Owner's Manual

assembly and adjustments
ALIGNMENT INSTRUCTIONS
GUARD ASSEMBLY
LOCK KNOB
GUABDCLAM_
SCREW
;HT RECEPTACLE
LATCH-PIN HANDLE
BEVEL LOCK KNOB
Figure 5
NOTE: The following instructions are pre
sented in the most logical sequence in which
they can be done to ensure accurate perform
ance of your saw.
C.
d.
Loosen the guard-clamp screw and remove the guard
assembly.
Place the arbor wrench on the shaft nut and the shaft
wrench on the hex portion of motor shaft just inside
the saw blade.
Hold the shaft wrench and rotate the arbor wrench
downward to loosen the shaft nut. The motor shaft
has left-hand threads.
e. Remove shaft nut, outer collar, saw blade, and inner
collar.
f. Place the saw blade, nut, collars, and guard assembty
where they will be out of your way during the
following adjustment steps.
Figure 6
1. Removing the Guard and Saw Blade (Figures 4, 5 and 6)
a, Tight_:n the carriage lock knob.
b, Disconnect the too!-tight cord.
2. Adjusting the Table Supports Parallel to the Radial Arm
(Figures 7 through 10)
IMPORTANT: Precise adjustment of the table
supports is necessary to assure consistently
true sawing operations. If the table supports-
and the table - are not precisely squared with
the saw-blade travel in all operating positions,
the blade may not produce clean, uniform
cuts.
a.
b.
Loosen the bevel lock knob and hold the latch-pin
handle up
Swivel the motor counterclockwise until the saw end
of the shaft is pointing straight down Tighten the
lock knob.