Icom IC-746PRO Instruction Manual page 18

1
PANEL DESCRIPTION
Front panel
i746PRO
NER ANT
NR NOTCH
A
NR /NOTCH
AF RF/SQL
F 1
MENU
MIC GAIN RF PWR CW PITCH KEY SPEED
#8 TRANSMIT FREQUENCY CHECK SWITCH [XFC]
(pgs. 45, 48)
Monitors the transmit frequency when pushed and
held.
• While pushing this switch, the transmit frequency can be
changed with the tuning dial, keypad or memo pad.
• When the split lock function is turned ON, pushing [XFC]
cancels the dial lock function. (p. 60)
#9 MEMO PAD-WRITE SWITCH [MP-W] (p. 67)
Programs the selected readout frequency and op-
erating mode into a memo pad.
• The 5 most recent entries remain in memo pads.
• The transmit frequency is programmed when pushed to-
gether with [XFC].
• The memo pad capacity can be expanded from 5 to 10
in set mode for your convenience. (p. 84)
$0 TRANSMIT INDICATOR [TX]
Lights red while transmitting.
$1 MEMO PAD-READ SWITCH [MP-R] (p. 67)
Each push calls up a frequency and operating
mode in a memo pad. The 5 (or 10) most recently
programmed frequencies and operating modes can
be recalled, starting from the most recent.
• The memo pad capacity can be expanded from 5 to 10
in set mode for your convenience. (p. 84)
$2 RECEIVE INDICATOR [RX]
Lights green while receiving a signal and when the
squelch is open.
$3 LOCK INDICATOR [LOCK] (p. 53)
Lights when the dial lock function is activated.
5
(continued)
% 2
HF/VHF TRANSCEIVER
F 2 F 3 F 4 F 5
SSB CW/RTTY AM/FM FILTER
P.AMP/ATT NB VOX/BK-IN MONITOR
% 1 % 0 $ 9 $ 8
1.8 1 3.5 2 7 3
F-INP
10 4 14 5 18 6
7 8 9
21 24 28
SPLIT
50 0 144 ENT
GENE
A /B
MP - W MP - R TS
TX RX
LOCK
XFC
LOCK/
CALL
SPCH
$4 QUICK TUNING SWITCH [TS] (p. 21)
Turns the quick tuning step ON and OFF.
• While the quick tuning indicator is displayed, the fre-
quency can be changed in programmed kHz steps.
• 0.1, 1, 5, 9, 10, 12.5, 20 and 25 kHz quick tuning
steps are available.
While the quick tuning step is OFF, turns the 1 Hz
step ON and OFF when pushed for 1 sec.
• 1 Hz indication appears in and the frequency can be
changed in 1 Hz steps.
While the quick tuning step is ON, enters the
quick tuning step set mode when pushed for
1 sec.
$5 VFO SELECT SWITCH [A/B] (p. 20)
Push to toggle between VFO A and VFO B.
Push for 1 sec. to equalize the frequency and op-
erating mode of the two VFO's.
TWIN PBT
$ 7
$ 6
PBTC MW
$ 5
V / M M-CL
$ 4
M-CH
$ 3
$ 2
∂TX
RIT CLEAR $ 1
$ 0
RIT/∂TX
# 9
# 8
Quick tuning indicator