Finishing Installation Of The Ooma Hub - ooma Hub User Manual

34

Finishing Installation of the ooma Hub

The last step in installing the ooma Hub device is to connect a phone and power.
Use a phone cable to plug your phone into the port labeled
1
cable has been provided).
Plug one end of the AC adaptor into the port labeled
2
power outlet. The clear ooma Tab, at the top left corner of the ooma Hub device, should light up red as
it boots up.
Power on your network devices (modem, switch, router). Wait a few minutes for everything to boot up.
3
Turn on your computer and connect to the Internet. Open up a web browser to make sure you are
4
online. This will allow the ooma Hub to complete its configuration.
Within a few minutes, the clear ooma Tab should turn blue. Pick up a phone connected to the ooma Hub. You
will hear the signature ooma dialtone. This confirms your ooma system has been properly configured.
PHONE POWER
on the ooma Hub (a short phone
PHONE
on the ooma Hub and the other end into a
POWER
installing the ooma hub