Stopping The Engine; Using The Self-Propel Drive; Mulching The Clippings - Toro Super Bagger 20192 Operator's Manual

Figure 20
3. Hold the blade control bar against the handle and
pull the recoil starter (Figure 21).
Figure 21
1. Blade control bar
Note: If the mower does not start, contact an
Authorized Service Dealer.

Using the Self-propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the mower will automatically keep pace with
you (Figure 22).
Figure 22
1. Nudge here
Note: If, when backing up after self-propelling, the
mower does not roll backward freely, nudge the mower
forward about an inch or two without engaging the
self-propel drive (Figure 22), then pull the mower
backward.

Stopping the Engine

Service Interval: Before each use or daily
To stop the engine, release the blade control bar
(Figure 23).
Important: When you release the blade control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.

Mulching the Clippings

Your mower comes from the factory ready to mulch the
grass and leaf clippings back into the lawn.
If the grass bag is on the mower, remove it (refer to
Removing the Grass Bag) before mulching the clippings.
If the side discharge chute is on the mower, remove it
and lock the side discharge door (refer to Removing the
Side Discharge Chute) before mulching the clippings.
Important: The mower has a safety switch that
prevents you from starting the mower unless you
first install the mulch plug securely on the mower
(Figure 24).
10
Figure 23