Recording; Recording The Input Source - Onkyo TX-8255 Instruction Manual

Recording

Unless you have the full consent of the copyright holder, copyright laws prohibit using your
recordings for anything other than personal enjoyment!
This section explains how to record the selected input source to a component with recording capability.

Recording the Input Source

You can record an audio signal on a recording
component connected to the TAPE 1 OUT or TAPE 2
OUT jacks.
When you record an audio signal on a recording
component connected to the TAPE 2 OUT jacks, you can
monitor the recorded sound. For details, refer to the
section "Monitoring the Recorded Sound" below.
When you want to record the input from the TAPE 2 IN
jacks, you cannot record the sound on a recording
component connected to the TAPE 1 OUT jacks.
1
Prepare the recorder:
• Set the recorder so that it's ready for
recording.
• If necessary, adjust the recording level on the
recorder.
• See the recorder's manual for more
information.
2 Use an input selector button other than
"TAPE 2 MONITOR" to select the
component that you want to record
from.
3 Start playback on the component
selected in step 1.
Note:
If you select another input source during
recording, the newly selected input source will
be recorded.
Note:
The volume, balance, mute and tone controls have no
effect on the signal being recorded.
Input selector buttons
TAPE1 TAPE2 MONITOR
23