Circuit Breaker - Toro 20052 Operator's Manual

4. Squeeze control bar to handle (Fig. 18).
Figure 18
1. Control bar
Note: Keep mower running when turning mower. Turning
mower off when making a turn does not save battery
energy.
To Stop Motor
1. Release control bar.
2. Remove key from plug receptacle if mower will be
unattended for any period of time. Hang key in a high
place out of reach of children.
3. Always charge battery immediately after each use
of mower. If battery is not charged after each use,
battery life will be shortened. See Charging Battery
in Before Starting section.
IMPORTANT: Your mower has been designed to be
safe if left continually on charge for extended periods
of time. It is recommended that the battery be left
continually on charge when it is not in use during the
mowing season. During the non-mowing season, the
mower can be unplugged and stored if the battery is
fully charged.

Circuit Breaker

If mower is run under too much load, the circuit breaker
will trip. Follow these instructions to reset circuit breaker.
IMPORTANT: Never reset circuit breaker when key is
in receptacle and control bar is squeezed to handle.
1. Remove key from plug receptacle (Fig. 19).
2. Wait 30 seconds to 1 minute before pushing in circuit
breaker button (Fig. 19).
3. Reinstall key in plug receptacle.
4. Resume cutting under less load.
If circuit breaker repeatedly trips, raise the height-of-cut
m-3706
or side discharge.
1. Key
Figure 19
2. Circuit breaker button
EN–12
2211