Table of Contents
Advertisement
4. Squeeze control bar to handle (Fig. 14).
Figure 14
1. Control bar
Note: Keep mower running when turning mower. Turning
mower off when making a turn does not save battery
energy.
To Stop Motor
1. Release control bar.
2. Remove key from plug receptacle if mower will be
unattended for any period of time. Hang key in a high
place out of reach of children.
3. Always charge battery immediately after each use
of mower. If battery is not charged after each use,
battery life will be shortened. See Charging Battery
in Before Starting section.
IMPORTANT: Toro designed your mower battery to
be safe if left continually on charge for extended
periods of time. It is recommended that the battery be
left continually on charge when it is not in use year
round. During the non-mowing season, the mower can be
unplugged and stored if the battery is fully charged;
however, there is a greater chance of battery failure if you
forget to charge the battery periodically.
Circuit Breaker
If mower is run under too much load, the circuit breaker
will trip. Follow these instructions to reset circuit breaker.
IMPORTANT: Never reset circuit breaker when key is
in receptacle and control bar is squeezed to handle.
1. Remove key from plug receptacle (Fig. 15).
2. Wait 30 seconds to 1 minute before pushing in circuit
breaker button (Fig. 15).
3. Reinstall key in plug receptacle.
4. Resume cutting under less load.
m-3706
If circuit breaker repeatedly trips, raise the height-of-cut
or use the side discharge option.
1. Key
12
Figure 15
2. Circuit breaker button
2211
Advertisement
Table of Contents
