Speaker Package HTP-780
Front speakers (SKF-780 L/R)
Center speaker (SKC-780)
Surround speakers (SKR-780 L/R)
Surround back speakers (SKB-780 L/R)
Subwoofer (SKW-780)
(➔
Speaker cables for front speakers 11 ft. (3.5 m)
(White and Red)
(➔
17)
Speaker cable for center speaker 10 ft. (3.0 m)
(Green)
(➔
17)
Speaker cables for surround speakers 26 ft. (8.0 m)
(Blue and Gray)
(➔
17)
Speaker cables for surround back speakers 26 ft.
(8.0 m) (Brown and Tan)
(➔
RCA cable for subwoofer connection 10 ft. (3.0 m)
(➔
17)
2 speaker bases and 8 screws
4 cork stoppers for center speaker
4 floor pads for the subwoofer
Universal Port Option Dock for iPod
(UP-A1)
UP-A1
(➔
56)
Using the Remote Controller
Installing the Batteries
Note
• If the remote controller
doesn't work reliably, try
replacing the batteries.
• Don't mix new and old
batteries or different
types of batteries.
• If you intend not to use
the remote controller for
a long time, remove the batteries to prevent damage from leak-
age or corrosion.
• Remove expired batteries as soon as possible to prevent damage
from leakage or corrosion.
Aiming the Remote Controller
To use the remote controller, point it at the AV receiver's
remote control sensor, as shown below.
Remote control sensor
(➔
10)
(➔
10)
(➔
10)
(➔
10)
10)
17)
(➔
14)
(➔
15)
(➔
15)
®
Batteries (AA/R6)
AV receiver
Approx. 16 ft. (5 m)
Contents
Introduction
Precautions ....................................................................... 3
Features ............................................................................ 6
Speaker Package ............................................................ 10
Basic Operations ............................................................ 25
Recording........................................................................ 32
Advanced Setup ............................................................. 38
Zone 2.............................................................................. 53
Controlling iPod ............................................................. 56
Troubleshooting ............................................................. 64
Specifications ................................................................. 69
About HDMI ..................................................................... 72
To reset the AV receiver to its factory defaults, turn it
on and, while holding down VCR/DVR, press
ON/STANDBY
64).
(➔
En
5