Lawn Mower Safety Warnings; Residual Risk; Transportation And Storage - Ryobi RLM36X40H40 Original Instructions Manual

Hide thumbs Also See for RLM36X40H40:
Table of Contents

Advertisement

When battery pack is not in use, keep it away from
connection from one terminal to another. Shorting the
battery pack terminals together may cause sparks,
burns, fire or explosion.
Do not place battery products or their batteries near
fire or heat. This increases the risk of explosion and
Do not open or mutilate the battery pack. Released
electrolyte is corrosive and may cause damage to the
eyes or skin. It may be toxic if swallowed.
Protect the battery pack against moisture and water.
Do not charge the product in a damp or wet location.
Following this rule will reduce the risk of electric shock.
In case of damage and improper use of the battery,
vapour may be emitted. Provide for fresh air and seek
medical help in case of complaints. The vapour can
irritate the respiratory system.
Do not leave the battery pack in a vehicle in hot summer
or cold winter conditions.
Do not incinerate the battery.
the battery; avoid contact. If contact accidentally occurs,
flush with water. If liquid contacts eyes, additionally
cause irritation or burns.

LAWN MOWER SAFETY WARNINGS

Before using, always visually inspect to ensure blades,
blade bolts, and cutter assembly are not worn or
damaged.
Replace worn or damaged blades and bolts in sets to
preserve balance.
The blade on this mower is sharp, use extreme caution
and wear heavy duty gloves when fitting, replacing,
cleaning or checking bolt security.
Return to an authorised service centre to replace
damaged or unreadable labels.
Check all nuts, bolts, and screws at frequent intervals
for proper tightness to be sure the equipment is in safe
working condition.
Check the grass box frequently for wear, holes or
deterioration.
Replace worn or damaged parts before operating the
product.
Never operate the machine if the on/off switch on the
handlebar does not properly start and stop the mower.
Never attempt to lock the on/off switches in the ON
position, this is extremely dangerous.
safer at the speed for which it was designed.
Stop the blade when crossing gravel surfaces.
Do not pull the product backward unless absolutely
necessary. If you must back the product away from a
wall or obstruction, first look down and behind to avoid
tripping or pulling the product over your feet.
2
Stop the motor and allow the blade to stop if the
mower has to be tilted for transportation when crossing
surfaces other than grass, and when transporting the
product to and from the area to be mowed.
Never use the product with defective guards or shields,
or without safety devices, for example, deflectors and/
or grass boxes, in place.
Do not tilt the lawn mower when switching on the motor
or whilst the motor is running. This exposes the blade
Switch on the motor carefully according to instructions
and keep hands and feet away from cutting area. Keep
clear of the discharge opening at all times. Do not start
the machine when standing in front of the discharge
opening.
Do not put hands or feet near or under rotating parts.
Keep clear of the discharge opening at all time.
Never pick up or carry the product while it is running.
Stop the mower motor and remove isolator key, make
sure that all moving parts have come to a complete stop
for the below cases:
whenever you leave the product unattended
(including disposal of grass clippings).
before cleaning a blockage or unclogging discharge
chute
before checking, cleaning or working on the product
for damage and make repairs as necessary before
restarting and operating the machine.
before removing the grass box or opening the grass
discharge chute cover.
If the machine starts to vibrate abnormally (check
immediately)
inspect for damage, particularly the blades
replace or repair any damaged parts
check for and tighten any loose parts
Avoid holes, ruts, bumps, rocks, property stakes, or
and fall accident.

RESIDUAL RISK

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and the
operator should pay special attention to avoid the following:
time and exposure.
protection and limit exposure.
Contact with blades

TRANSPORTATION AND STORAGE

Stop the machine, remove the isolator key and the
battery, make sure that all moving parts have come to
a complete stop, and allow it to cool before storing or
transporting.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rlm36b40h

Table of Contents