LG DLEX5780*E Owner's Manual page 20

20 INSTA LLAiTION INSTRUCTIONS
Reversing fhe Door (continued)
Make sure the top of the side lock rod is beside the top
lock rod and the two do not overlap each other, so the
two rods can interact correctly. If they are not aligned
properly, the door will not operate properly.
16. Reinstall the top interlock buttons.
Reinstall the top gray interlock buttons removed in
step 7, one on each side of the outer door panel.
17, Reinstall the side interlock button.
Reinstall the side interlock button removed in step 8.
Center the spring in the compartment and insert the
interlock button on top of it.
'4
18. Reinstall the door cover.
Clean the glass on the door and door cover, if
necessary.
Make sure the three gray interlock buttons are
properly installed and that the top and side lock
rods are properly aligned where they meet. Carefully
lower the door cover into place, aligning the holes in
the cover with the interlock buttons on the top and
side and the bumpers on the bottom. Take care not
to dislodge the lock rods while mounting the door
cover. Once the door cover is in place, secure it with
the 12 screws removed in step 4.
The ten similar screws go around the top and sides
of the door cover. Make sure to install the two
different screws on the bottom edge, in the locations
marked below
interlock
buttons
_ ///,bumpers
19. Now, pick up the upper hinge pivot removed earlier and
rotate it 180 degrees. Press in the side interlockbutton
on the left side and hold it down while you pressthe hinge
pivot into the hinge assembly on the top right side. If the
door hasbeen reassembled correctly, the lock rod will slide
back easily and lock the pivot in place.The door is now
ready to remount on the opposite side of the dryer.
A, WARNING
Be sure to support the weight of the door before installing
the hinge screws.
20. Reinstall the door.
While supporting the door, install the four hinge screws
removed in step 2. Testthe swing of the door to make sure
the hinges and latch are properly aligned and that the
door opens, closes and latches properly in both directions.
Two large
screws
Two small
screws
If the door doesn't operate smoothly, remove the door
and then the door cover to check that the lock rods and
interlock buttons are properly mounted and aligned.
The interlock buttons should be oriented correctly and
operating smoothly. The interlock rods should be in the
proper position and should not overlap at the contact
point. (See steps 13-15.)
If the door is damaged, or if the door does not work after
reassembly, contact the call center at 1-800-243-0000.