Advertisement
ENGLISH
6
Problem
When I use pre-ground
coffee, the coffee is too
weak.
The filter overflows when
I remove the jug from the
appliance while it
is brewing coffee.
The appliance continues to
drip long after the brewing
process has ended.
The coffee is not
hot enough.
The coffeemaker does
not start cleaning the
grinder funnel.
The appliance works but
makes a beeping sound.
The coffee beans seem to
be used up quickly.
Possible solution
Make sure the amount of pre-ground coffee in the filter is consistent
with the amount of water in the water reservoir. Please keep in mind
that the appliance uses all the water in the water reservoir.
Use ground coffee of a stronger blend or flavour.
To increase the coffee strength, increase the amount of pre-ground
coffee or decrease the amount of water.
If you remove the jug for more than 20 seconds during the brewing
process, the drip stop causes the filter basket to overflow. Also note
that the coffee does not reach its full taste before the end of the
brewing process. Therefore we advise you not to remove the jug and
pour out the coffee before the end of the brewing process.
The dripping is caused by condensation of steam. It is completely
normal that the appliance drips for some time.
If the dripping does not stop, the drip stop may be clogged. To clean
the drip stop, pull at the tab of the filter basket holder on the right
side of the coffeemaker to open the holder. Take out the filter basket.
Then rinse the filter basket and the drip stop under the tap.
If you remove the jug for more than 20 seconds during the brewing
process, the drip stop causes the filter basket to overflow.
Preheat the jug with hot water before you start brewing coffee.
The coffee in the jug cools down faster if you brew only a few cups.
The coffee stays hot longer if you brew 10 cups, which is a full jug.
Use thin-walled cups, because they absorb less heat from the coffee
than thick-walled cups.
Do not use milk that comes directly out of the fridge.
Descale the appliance. See section 'Descaling the coffeemaker' in
chapter 'Cleaning and maintenance'.
Make sure that the coffeemaker is connected to the mains.
Make sure that you open the lid of the grinder funnel before you
press and hold the grinder button.
Press and hold the grinder button for 4 seconds until the grinder
starts cleaning itself.
Please check if the lid of the grinder funnel is closed properly.
It may look as if the coffee beans are used up quickly. To ensure a
perfect cup of coffee, a certain amount of ground coffee is required.
The amount of coffee beans the appliance uses to get the perfect
amount of ground coffee is normal.
Advertisement
