Using The Remote Control; Licenses; Connections - Panasonic SC-RS52 Operating Instructions Manual

Using the remote control

Insert the battery so the terminals (i and j) match
those in the remote control.
Point it at the remote control signal sensor on this unit.
≥ To avoid interference, please do not put any objects in front
of signal sensor.

Licenses

The Bluetooth word mark and logos are registered trademarks
®
owned by Bluetooth SIG, Inc. and any use of such marks by
Panasonic Corporation is under license.
Other trademarks and trade names are those of their respective
owners.
MPEG Layer-3 audio coding technology licensed from
Fraunhofer IIS and Thomson.
∫ About recorded content
Please note that even if content is not recorded
correctly due to any defects, Panasonic will not be
responsible for compensation for such content, losses
arising out of the recorded content, or any direct or
indirect damage caused by such recording. The same
also applies to repairing this unit.
R6/LR6, AA
(Alkaline or manganese
battery)

Connections

Connect the AC mains lead after all other
connections are completed.
2
1
Connect the antenna.
This unit can receive DAB/DAB+ and FM stations
with the DAB antenna.
≥ Tape the antenna to a wall or column in a position with
the least amount of interference.
≥ If radio reception is poor, use a DAB outdoor antenna
(not supplied).
Be sure to tighten
the nut fully.
2
Connect the AC mains lead.
AC mains lead (supplied)
This unit consumes a small amount of AC power
(l 21) even when turned off.
≥ In the interest of energy conservation, if you will not be using
this unit for an extended period of time, unplug it from the
mains socket.
≥ Some settings will be lost after you disconnect the system.
You have to set them again.
1
Adhesive tape (not supplied)
DAB indoor antenna
(supplied)
To a mains socket
5
RQT0A76