Touch Panel Adjustment - Kenwood DDX7032 Service Manual

NG
Enlarge NG
● Confi rmation after the adjustment
After the adjustment, confi rm that the screen is horizon-
tally symmetrical.
The "HPOSI OK" will be displayed to indicate the com-
pletion of the adjustment.
Note: Do not adjust HPOSI after the adjustment of DOT
PHASE.

4. Touch panel adjustment

● Adjustment procedure
q Press the Touch Key on the Test Mode Menu screen to
enter the Touch panel adjustment screen.
w Touch the center of "+" mark below in the following or-
der.
Upper left → Upper right → Lower left → Lower right
To touch, make sure to use the designated touch stick.
ADJUSTMENT
e After adjustment is completed for 4 areas, if "Write OK"
is displayed, the adjustment is completed.
Press Return to exit from the Touch screen.
∗ If the center of "+" mark wasn't pressed accurately, press
Cancel to start over the adjustment.
Note
The touch panel adjustment data is fi nalized when the touch
stick is released from the mark.
Therefore, the Knack for Adjustment is not to release the
touch stick from the mark right after touching the center of
the "+" mark, but to confi rm that the stick is exactly on the
center of the "+" mark while keeping touching the screen. (If
the stick is not exactly on the center of the mark, move the
stick onto the center of the mark while keeping touching the
screen.)
Then, quickly and vertically release the stick from the
screen.
DDX7032/7032M/712
DNX7120/7220/7320
Cancel Cancel
Cancel Cancel
37