Brother GT-341 Instruction Manual page 122

6. Maintenance
(10) Use the one side of wet Clean Stick to clean the front side of the Wiper Blade.
(11) Use the other side of the wet Clean Stick to clean the rear of the Wiper Blade. Do not wipe the White / Color
with the same Clean Stick.
(12) Wet other two Clean Sticks and use them to remove ink or dust from the Print Head Caps.
Use one side of the Clean Stick to clean one Print Head Cap.
<Note>
Do not use dry Clean Stick; it cannot clean ink or dust. It may damage the Print Head Caps. Wipe off the dirty
ink of Clean Sticks with soft cloth if it is too dirty and wet with Wash Liquid.
(13) Mount the new Wiper Cleaner by following (6) to (4) in the previous pages.
<Note>
Do not give stress to the Timing Belt in mounting the Wiper Cleaner.
If your printer turns on with no errors, replacement of the Wiper Cleaner has been completed successfully.
If something irregular occurs, e.g. abnormal noise or error "No Wiper Cleaner (CMYK/White)", turn off your
printer, and check if the Wiper Cleaner is correctly mounted.
112
GT-3 Series
0063Y
0064Y
0065Y
0066Y