Advanced Setup; Advanced Speaker Settings - Onkyo HT-R550 Instruction Manual

Advanced Setup

Advanced Speaker Settings

This section explains how to check the speaker settings
and how to set them manually, which is useful if you
change a speaker after performing the automatic speaker
setup.
Some speaker settings are set automatically by the Auto-
matic Speaker Setup function (see page 37).
Speaker Configuration
These settings are set automatically by the Automatic
Speaker Setup function (see page 37).
This section explains how to specify which speakers are
connected and their sizes.
For speakers with a cone diameter
larger than 6-1/2 inches (16 cm),
specify Large (full band). For those
with a smaller diameter, specify
Small (default crossover 100 Hz).
The crossover frequency can be
changed on page 57.
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
RECEIVER
SETUP
2
Use the Up and Down [
buttons to select "Sp Config,"
and then press the [ENTER] but-
ton.
3
While the Subwoofer setting is
selected, use the Left and Right
[
No.
56
Cone diameter
]/[ ] buttons to select Yes or
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
4
5
6
]/[ ]
Use the Down [ ] button to
select "Front," and then use the
Left and Right [ ]/[
select Small or Large.
Small: Select if the front speakers are
small.
Large: Select if the front speakers are
large.
Note:
• If the Subwoofer setting in step 3 is
set to No, this setting is fixed at Large
and does not appear.
Use the Down [ ] button to
select "Center," and then use the
Left and Right [ ]/[
select Small, Large, or None.
Small: Select if the center speaker is
small.
Large: Select if the center speaker is
large.
None: Select if no center speaker is
connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
Use the Down [ ] button to
select "Surround," and then use
the Left and Right [
tons to select Small, Large, or
None.
Small: Select if the surround speak-
ers are small.
Large: Select if the surround speak-
ers are large.
None: Select if no surround speakers
are connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
] buttons to
] buttons to
]/[ ] but-