Onkyo AVX-280 Instruction Manual page 40

Note
• Enter the appropriate remote control code before using the AV
receiver's remote controller for the first time
• Connect the RI Dock to the AV receiver with an u cable
(➔ 38).
• Set the RI Dock's RI MODE switch to "HDD" or "HDD/
DOCK".
• Set the AV receiver's Input Display to "DOCK"
■
System Function
System On
When you turn on the AV receiver, the RI Dock and iPod
turn on automatically. In addition, when the RI Dock and
iPod are on, the AV receiver can be turned on by pressing
ON/STANDBY.
Auto Power On
If you press the remote controller's 1 while the AV
receiver is on Standby, the AV receiver will automatically
turn on, select your iPod as the input source, and your
iPod will start playback.
Direct Change
If you start iPod playback while listening to another input
source, the AV receiver will automatically switch to the
input to which the RI Dock is connected.
Other Remote Controllers
You can use the remote controller that came with the AV
receiver to control other iPod functions. The available
functionality depends on the AV receiver.
iPod Alarm
If you use the Alarm function on your iPod to start play-
back, the AV receiver will turn on at the specified time and
select your iPod as the input source automatically.
Note
• Linked operations do not work with video playback or when the
alarm is set to play a sound.
• If you use your iPod with any other accessories, iPod playback
detection may not work.
• This function only works when the Standard mode is set to On.
■
Operating Notes
• Use the AV receiver's volume control to adjust the playback
volume.
• While your iPod is inserted in the RI Dock, its volume control
has no effect.
• If you do adjust the volume control on your iPod while it's
inserted in the RI Dock, be careful that it's not set too loud
before you reconnect your earphones.
En
40
Controlling Your iPod
By pressing REMOTE MODE that's been programmed
(➔ 42).
with the remote control code for your Dock, you can con-
trol your iPod in the Dock with the following buttons.
See "Entering Remote Control Codes" for details on
entering a remote control code
22).
(➔
See to the Dock's instruction manual for more informa-
tion.
■
UP-A1 Dock
PORT is preprogrammed with the remote control code for
controlling a Dock with Universal Port connector.
You can control your iPod when "PORT" is selected as
the input source.
Without the RI Control
You must enter a remote control code 82990 first
■
RI Dock
• Set the RI Dock's RI MODE switch to "HDD" or "HDD/
DOCK".
• ON/STANDBY may not work with a remote control
code (without u). In this case, make an u connection
and enter a remote control code 81993 (with u).
With the RI Control
In this case, make an u connection and enter a remote
control code 81993 (with u).
• Set the AV receiver's Input Display to "DOCK" (
42).
(➔
(➔ 42).
➔
).
22