Onkyo AVX-280 Instruction Manual page 13

Connecting the Speaker Cables
Screw-type speaker terminals
Strip 1/2" to 5/8" (12 to 15 mm) of insu-
lation from the ends of the speaker
cables, and twist the bare wires tightly,
as shown.
(Supplied speaker cables are already
stripped.)
Using Banana Plugs
• If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.
• Do not insert the speaker code directly into the center hole of the speaker terminal.
Push-type speaker terminals
Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of the
speaker cables, and twist the bare wires tightly, as shown.
(Supplied speaker cables are already stripped.)
The following illustration shows which speaker should be connected to each pair of terminals.
Surround Surround
right left
speaker speaker
Gray Blue
Red
Front right Front left
speaker A speaker A
Speakers A
1/2" to 5/8" (12 to 15 mm)
Center speaker
Green
White
Purple
Subwoofer
3/8" to 1/2" (10 to 12 mm)
Front right
Front left
speaker B
speaker B
Speakers B
En
13