Table of Contents
Advertisement
Hour Meter
The hour meter (Figure 4) shows the total hours that the
machine has been operated.
Temperature Override Switch
Press and hold the reset switch (Figure 4) to start the
engine after high temperature shut down. Use only for
emergency operation.
Audible Alarm
The alarm (Figure 4) is activated when the low engine
oil pressure light illuminates or the high coolant
temperature light illuminates.
Alarm Silence Switch
This switch (Figure 4) shuts off the audible alarm.
Specifications
Note: Specifications and design are subject to change without notice.
Width of cut
overall
front cutting unit
side cutting unit
front and one side cutting unit
Overall width
cutting units down
cutting units up (transports)
Overall length
Height
Height with ROPS
Ground clearance
Wheel tread (to center of tire)
front
rear
Wheel base
Weight (with cutting units and fluids)
Throttle Control
Move the control (Figure 4) forward to increase the
engine speed and rearward to decrease the speed.
Power Point
The power point (Figure 4) is used to power optional
electrical accessories.
Engine Cooling Fan Switch
The machine is equipped with a hydraulically driven auto
reversing engine cooling fan. The fan switch (Figure 4)
has three positions R (manual reverse), Auto (normal)
and F (forward only). Refer to Engine Cooling Fan
Operation in the Operation Section of manual
Attachments/Accessories
124 inch (315 cm)
A selection of Toro approved attachments and
accessories are available for use with the machine to
54 inch (137 cm)
enhance and expand its capabilities. Contact your
37 inch (94 cm)
Authorized Service Dealer or Distributor or go to
89 inch (226 cm)
www.Toro.com for a list of all approved attachments
and accessories.
127 inch (322 cm)
71 inch (180 cm)
144 inch (366 cm)
58 inch (147 cm)
81 inch (206 cm)
6 inch (15 cm)
45 inch (114 cm)
47 inch (119 cm)
55-1/2 inch (141 cm)
4211 lb (1910 kg)
17
Advertisement
Table of Contents
