Table of Contents
Advertisement
2. Remove or add "C" shaped spacers at the narrow
portion of the spindle shaft, below the castor arm, to get
the desired height-of-cut. Make sure that the thrust
washers, not the spacers, contact the top and bottom of
the castor arm.
3. Install the tensioning cap to secure the assembly.
4. Ensure that all four castor wheels are set at the same
height-of-cut.
Adjusting the Rollers and Gage
Wheel
Note: If the cutting unit is to be used in the 1 in. (25 mm)
or 1-1/2 in. (38 mm) height-of-cut setting, the cutting unit
rollers must be repositioned in the top bracket holes.
Adjusting the Front Roller
1. Remove the capscrew and nut securing the roller shaft
to the cutting unit bracket (Fig. 14).
2. Slide the shaft out of the lower bracket holes, align the
roller with the top holes, and install the shaft.
3. Secure the roller shaft to the cutting unit bracket with
the capscrew and nut.
1
Figure 14
1. External roller
2
2. Roller shaft
14
Adjusting the Front Gage Wheel
1. Remove the capscrew and nut securing the gage wheel
to the cutting unit brackets (Fig. 15).
2. Align the roller and spacer with the top holes in the
brackets and secure them with the capscrew and nut.
1
Figure 15
1. Gage wheel
Adjusting the Rear (Internal) Rollers
1. Remove the cotter pins securing the roller shafts to the
brackets on the underside of the deck (Fig. 16).
2. Slide the shafts out of the lower bracket holes, align the
rollers with the top holes, and install the shafts.
3. Install the cotter pins to secure the assemblies.
1
Figure 16
1. Internal rollers
Advertisement
Table of Contents
