stationary idler pulley and adjustable idler pulley.
6.
Install the gear box base with carriage bolts and locknuts.
7.
Using a torque wrench, adjust the tension of idler pulley
against the belt: refer to Adjusting The Idler Pulley.
8.
Reinstall covers and secure latches.
MODEL AND SERIAL NUMBERS
The cutting deck has two identification numbers: a model number
and a serial number. The two numbers are stamped into a plate
which is located on carrier frame behind the right front castor
wheel. In any correspondence concerning the mower, supply the
model and serial numbers to assure that correct information and
replacement parts are obtained.
To order repIacement parts from an authorized TORO Distributor,
supply the foIlowing information:
1.
Model and serial numbers of the machine.
2.
Part number, description and quantity of parts desired.
Note: Do not order by reference number if a parts cataIog is being
used; use the part number.
22
Figure 20
Figure 21
1.
Model and serial number