Checking The Bidirectional Clutch Lubricant (Model 30345 Only); Using The Rollover Protection System (Rops) - Toro 30344 Operator's Manual

Figure 26
1. Check plug
Figure 27
1. Fill/check plug (one on each end of axle)
Checking the Bidirectional
Clutch Lubricant (Model 30345
only)
1. Position the machine on a level surface.
2. Rotate the clutch (Figure 28) so that the check plug
(shown in the 12 o'clock position) is positioned at 4
o'clock.
Figure 28
1. Bidirectional clutch
3. Remove the check plug.
2. Fill plug
2. Check plug
The fluid level should be up to the hole in the
clutch. If the fluid level is low, add Mobil Fluid 424.
The clutch should be approximately 1/3 full.
4. Install the check plug.
Note: Do not use engine oil (i.e. 10W30) in the
bidirectional clutch. Anti-wear and extreme pressure
additives will cause undesirable clutch performance.
Note: Determine the left and right sides of the
machine from the normal operating position.
Using the Rollover Protection
System (ROPS)
To avoid injury or death from rollover: keep the
roll bar in the raised locked position and use
the seat belt.
Ensure that the rear part of the seat is secured
with the seat latch.
There is no rollover protection when the roll bar
is in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
• Lower roll bar slowly so damage to hood
does not occur.
Important: Lower the roll bar only when
absolutely necessary.
1. To lower the roll bar, remove the hairpin cotter pins
and remove the two pins (Figure 29).
31