Checking The Rear Axle Lubricant (Model 30345 Only); Checking The Bidirectional Clutch Lubricant (Model 30345 Only) - Toro 30344 Operator's Manual

1. Fuel-tank cap
3. Remove the cap from the fuel tank
4. Fill the tank until the level is to the bottom of the filler
neck with diesel fuel.
5. Install fuel-tank cap tightly after filling the tank.
Note: If possible, fill the fuel tank after each use. This
will minimize possible buildup of condensation inside
the fuel tank.
Checking the Rear Axle
Lubricant (Model 30345 only)
The rear axle has 3 separate reservoirs that use SAE 80W-90
weight gear lube. Although the axle is shipped with lubricant
from the factory, check the level before operating the machine.
1. Position the machine on a level surface.
2. Remove the check plugs from the axle and ensure that
there is lubricant up to the bottom of each hole. If the
level of lubricant is low, remove the fill plugs and add
enough lubricant to bring the level up to the bottom of
the check-plug holes
1. Check plug
Figure 26
(Figure 26).
(Figure 27 and Figure 28).
Figure 27
2. Fill plug
1. Fill/check plug (1 on each end of axle)
Checking the Bidirectional
Clutch Lubricant (Model 30345
only)
1. Position the machine on a level surface.
2. Rotate the clutch
is positioned at 4 o'clock.
The check plug is shown in the 12 o'clock position.
1. Bidirectional clutch
3. Remove the check plug.
Note: The fluid level should be up to the hole in the
clutch. If the fluid level is low, add Mobil Fluid 424.
The clutch should be approximately 1/3 full.
4. Install the check-plug.
Note: Do not use engine oil (such as 10W30) in the
bidirectional clutch. Anti-wear and extreme pressure
additives cause undesirable clutch performance.
Note: Determine the left and right sides of the
machine from the normal operating position.
31
Figure 28
(Figure 29) so that the check plug
Figure 29
2. Check plug