Toro 29518 Operator's Manual page 32

5. Start the engine and drive to a flat area.
6. Check the engine-oil level.
Changing the Engine-Oil Filter
Service Interval: Every 200 hours
Note: Change the engine-oil filter more frequently when
operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to
Engine Oil (page 31).
2. Place a rag under the oil filter to soak up any spilled oil.
Important: Spilled oil may drain under the engine
and onto the clutch. Oil spilled on the clutch may
damage the clutch, cause the blades to stop slowly
when the clutch is in the Off position, and cause
the clutch to slip when the clutch is switched to
the On position. Wipe up any spilled oil.
3. Change the engine-oil filter
Figure 34
Changing the
(Figure 35).
Note: Ensure the oil-filter gasket touches the engine,
and then an extra 3/4 turn is completed.
4. Fill the crankcase with the specified type of new oil;
refer to Figure
32
Figure 35
31.