Toro 29518 Operator's Manual page 24

Loading the Machine onto a Transport
Vehicle
WARNING
Loading the machine onto a trailer or truck
increases the possibility of backward tip-over, and
could cause serious injury or death.
• Use extreme caution when operating a machine
on a ramp.
• Use only a single, full-width ramp; do not use
individual ramps for each side of the machine.
• If individual ramps must be used, use enough
ramps to create an unbroken ramp surface wider
than the machine.
• Do not exceed a 15-degree angle between ramp
and ground, or between a ramp, a trailer, or a
truck.
• Avoid sudden acceleration while driving
machine up a ramp to avoid tipping backward.
• Avoid sudden deceleration while backing
machine down a ramp to avoid tipping
backward.
Important: Do not attempt to turn the machine while
on the ramp; you may lose control and drive off the side.
•
Use extreme caution when loading units onto trailers or
trucks.
•
Use 1 full-width ramp that is wide enough to extend
beyond the rear tires is recommended instead of
individual ramps for each side of the machine
The platform, when down and locked into position, must
extend back between the rear wheels and serves as a stop
for tipping backward. Having a full-width ramp provides
a surface for the platform to contact if the machine starts
to tip backward. With the platform up, a full-width ramp
provides a surface to walk on behind the machine.
•
The ramp should be long enough so that the angles do
not exceed 15 degrees
cause tine components to get caught, as the machine
moves from ramp to trailer or truck. A steeper angle may
also cause the machine to tip backward. If loading on
or near a slope, position the trailer or truck so it is on
the down side of the slope and the ramp extends up the
slope. This will minimize the ramp angle. The trailer or
truck should be as level as possible.
(Figure
(Figure 23). A steeper angle may
1. Trailer
2. Full-width ramp
•
The operator should determine if it is best to have
the platform up or down when loading, depending on
conditions. If it is not possible to use one full-width ramp,
use enough individual ramps to simulate a full-width,
continuous ramp.
•
Avoid sudden acceleration when driving up a ramp and
sudden deceleration when backing down a ramp. Both
maneuvers can cause the machine to tip backward.
Transporting the Machine
23).
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all the necessary brakes,
lighting, and marking as required by law. Please carefully read
all the safety instructions.
To transport the machine:
1. Raise the tines of the machine before driving onto the
trailer or truck.
2. If using a trailer, connect it to the towing vehicle and
connect the safety chains.
3. If applicable, connect the trailer brakes.
4. Load the machine onto the trailer or truck.
5. Stop the engine, remove the key, set the brake, and
close the fuel valve.
6. Set the parking brake and block the tires.
7. Use the tie-down points on the machine to securely
bind the machine to the trailer or truck with straps,
chains, cable, or ropes
Note: Refer to your local ordinances for specific
trailer and tie-down regulations.
24
Figure 23
3. Not greater than
15 degrees
4. Full-width ramp (side view)
(Figure 24).