Table of Contents
Advertisement
Tighten adjusting screws 1.
If the motorcycle is
raised too far at the
front the center stand will lift
clear of the ground and the
motorcycle could topple to
one side.
When raising the motorcycle,
make sure that the center
stand remains on the
ground.
Apply uniform pressure
to push front wheel stand
down and raise motorcycle.
Lamps
General instructions
The failure of a bulb is
signaled in the display by
the lamp defect symbol. The
same bulbs are used for the
brake light and the tail light.
The luminosity is controlled
accordingly.
A defective bulb places
your safety at risk be-
cause it is easier for other
users to oversee you and
your motorcycle.
Replace defective bulbs as
soon as possible; always car-
ry a complete set of spare
bulbs if possible.
The bulb is pressurized
and can cause injury if
damaged.
Wear eye and hand protection
when replacing bulbs.
An overview of the bulb
types installed in your
motorcycle is provided in the
chapter "Technical Data".
Do not touch the glass
of new bulbs with your
fingers. For installation, use
a clean, dry cloth. Dirt de-
posits, in particular oil and
grease, interfere with heat ra-
diation from the bulb. Over-
heating and therefore short
service life of the bulbs are
the consequence.
Replacing low-beam or
high-beam bulb
If it is not standing firm-
ly, the motorcycle could
topple in the course of the
operations described below.
Make sure that the motorcy-
cle is steady on its stand.
7
109
z
Advertisement
Table of Contents
