Positioning The Seat; Pushing The Machine By Hand - Toro 74182 Operator's Manual

Operation

Positioning the Seat

The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
1. To adjust, tip seat forward and loosen the seat
mounting bolts (Fig. 10).
2. Slide the seat to the desired position in the
adjusting slots and tighten the mounting bolts.
2
Figure 10
1. Adjustment slot
2. Mounting bolt
18

Pushing the Machine by Hand

IMPORTANT: Always push the machine by
hand. Never tow the machine because
hydraulic damage may occur.
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to "OFF" to stop the engine.
2. Rotate pump by-pass valves counterclockwise 2
turns to push. This allows hydraulic fluid to
by-pass the pump enabling the wheels to turn
(Fig. 11).
1
IMPORTANT: Rotate by-pass valve a
maximum of 2 turns so the valve does not
come out of the body causing fluid to run out.
m–3280
1200
3. Release the parking brake.
To Operate the Machine
1. Turn the by-pass valves in to operate (Fig. 11).
Note:
1. By-pass valve
The machine will not drive unless
by-pass valves are turned in.
Figure 11
1
m–3305