Adjusting The Self-Propel Drive; Assembling The Grass Bag - Toro 22296 Operator's Manual

1. Dipstick
2. Upper-limit mark
Note: When the crankcase is empty, pour about 3/4 of the
crankcase capacity of oil in the crankcase, then follow the
procedure in this section.
1. Move the machine onto a level surface.
2. Clean around the dipstick
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out.
4. Wipe the dipstick clean with a clean cloth.
5. Insert the dipstick into the filler neck (but do not
rotate the cap clockwise to secure it), then remove
the dipstick.
6. Read the oil level on the dipstick.
•
If the oil level is below the lower-limit mark on the
dipstick, slowly pour a small amount of oil into
the oil-fill tube, wait 3 minutes, and repeat steps
through 6 until the oil level is at the Full mark on
the dipstick.
•
If the oil level is above the upper-limit mark on the
dipstick, drain the excess oil until the oil level on
the dipstick is at the Full mark. Refer to
the Engine Oil (page
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
7. Insert the dipstick into the filler neck and rotate the cap
clockwise until it is tight.
Figure 7
3. Lower-limit mark
(Figure 7).
Changing
18).
3

Adjusting the Self-Propel Drive

No Parts Required
Procedure
Important: You must adjust the self-propel-drive cable
before you operate the machine for the first time. Refer
to Adjusting the Self-Propel Drive (page
4

Assembling the Grass Bag

No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
1
4
2
1. Handle
2. Frame
Note: Do not slip the bag over the handle
2. Hook the bottom channel of the bag onto the bottom
of the frame
9
19).
g027289
3
Figure 8
3. Grass bag
(Figure 9).
Figure 8.
(Figure 8).