Toro 22291 Operator's Manual page 9

2. Install the handle ends onto the machine housing with
2 hex-head-flange bolts (5/16 x 1-1/2 inches) and 2
flange nuts (5/16 inch) as shown in
3. Set the machine to the desired cutting height; refer to
Adjusting the Cutting Height (page
4. Stand behind the machine in the operating position to
determine the handle height that is most comfortable
for you (Figure 4).
Figure 4
1. Handle
2. Handle bracket (2)
3. Highest handle height
5. Secure the handle onto the handle brackets at your
desired handle height with 2 carriage bolts (5/16 x
1-1/2 inches) and 2 flange nuts (5/16 inch) as shown
in Figure 5.
Important: Ensure that the bolt heads are on
the inside of the handle and the nuts are on the
outside of the handle.
Figure 3.
13).
4. Medium handle height
5. Lowest handle height
1. Carriage bolt—5/16 x
1-1/2 inches (2)
2. Handle bracket (2)
6. Position the cable guard onto the handle with the
cable(s) inside the guard, and secure the guard to the
handle with the 2 carriage bolts and the 2 locknuts that
you previously removed
Important: Ensure that you do not pinch the
cable(s) to the handle with when you install the
cable guards onto the handle.
9
Figure 5
3. Flange nut—5/16 inch (2)
(Figure 3).