Table of Contents
Advertisement
Troubleshooting— Continued
Trouble
The timer didn't work?
No sound is output when a
timed playback or record-
ing task starts?
doesn't work.
Standby indicator flashes.
Abnormal Behavior
The CR-505DAB contains a microcomputer for signal processing and control functions. In very rare situations, severe
interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should
happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.
Restoring the Default Settings
To reset the CR-505DAB to its factory defaults, turn it off and unplug the power cord. Then press and hold the [STANDBY/
ON] button on the CR-505DAB, and plug in the power cord.
Possible Cause
The CR-505DAB was already on at the
specified ON time.
The
-connected cassette tape deck or
MD recorder had not been in standby mode.
The specified ON time coincided, or over-
lapped the ON time of another timer.
The CR-505DAB is only connected digi-
tally to the MD recorder.
While a timed recording task is in progress,
the output of the CR-505DAB is muted.
For timed playback, the volume is deter-
mined by the [VOLUME] control.
There's no RCA/phono analog audio con-
nection.
The protection circuit may be activated.
Remedy
Set the CR-505DAB to Standby (page 33).
The CR-505DAB must be in Standby mode,
otherwise the timed task will not work.
You must set the recording devices to standby
mode too.
Check the timer settings and correct as neces-
sary (page 34).
To make recordings with
-connected MD
recorder, connect the recorder's analog inputs
to the CR-505DAB's analog outputs.
To hear what's being recorded, press the
[MUTING] button to cancel the Mute func-
tion. Press it again to mute the CR-505DAB.
Set the volume to a suitable level (page 19).
To use
you must make an analog audio
connection (RCA/phono) between CR-
505DAB and your Onkyo components even if
they are connected digitally.
Make sure not to short-circuit the positive and
negative speaker wires.
39
Advertisement
Table of Contents
